SPC File create

  This 12d panel creates a Special Chainage file containing set values for each alignment string selected in the Data source area. The name of the resulting SPC files will contain the name of the model and alignment string name.  A file suffix can be added if required. Please ensure you read and select the [...]
Read More

Special Chainage File

  This 12d tool is used to create a special chainage file for any alignment/super alignment string. The chainages are created for a selected reference string but can then be defined by dropping strings and/or individual points onto the reference string. The option will re-organise the chainage order to ensure they increase for you.  The [...]
Read More

CAD Point Toolbar – Divide Segment by Chainage Length

This tool is used to create CAD Points, by dividing a segment of an existing string by a chainage length. The video below will show how to create CAD Points by dividing a segment by a specified chainage length. Or continue down the page to see the CAD Point, Divide Segment by Chainage Length create [...]
Read More

CAD Point Toolbar – Chainage Offset Extended

This tool is used to create a CAD Point, located at a string Chainage and an Offset from the string, but the Chainage can be extended past the end of the string. The video below will show how to create a CAD Point Chainage Offset Extended. Or continue down the page to see the CAD [...]
Read More

CAD Point Toolbar – Chainage Offset

This tool is used to create a CAD Point, located at a string Chainage and an Offset from the string. The video below will show how to create a CAD Point Chainage Offset. Or continue down the page to see the CAD Chainage Offset create options. This CAD Point Chainage Offset option is found on [...]
Read More

CAD Point Toolbar – Chainage

This tool is used to create a new CAD Point, located at a specific Chainage on a selected string. The video below will show how to create a new CAD Point at a specific Chainage along an existing string. Or continue down the page to see the CAD Point Chainage create options. This CAD Point [...]
Read More

Measure String From Point

This tool is used to measure Chainage and Offset from a string to a point. Use: Utilities => Measure => String from point Once the panel is open: Select the String to measure - the Chainage will be measured along this string. Extend Mode: - No extending - Only the selected string will be utilised. [...]
Read More

Measure String from Cursor

This tool is used to measure Chainage and Offset of the a Cursor Position from a selected String. This option does not allow a point/string to be selected, but dynamically displays the cursor position information from the selected string to measure from. Use: Utilities => Measure => String from cursor Once the panel is open: [...]
Read More